How to choose valve materials (body and seals)
Updated:
Two valves of the same type can withstand very different conditions when made of different materials. Material choice depends on the fluid, temperature, pressure and whether the environment is corrosive. Below we cover body and seal (seat) materials separately.
Body materials
| Material | Typical designation | Strengths | Watch out for |
|---|---|---|---|
| Grey cast iron | EN-GJL-250, GG25 | Economical; water and low-pressure general lines | Brittle; not for impact, shock or high temperature |
| Ductile iron | EN-GJS-400-15, GGG40 | Tougher than grey iron; water, wastewater, general industry | Limited with strong acids and at high temperature |
| Carbon steel | A216 WCB, 1.0619 (GP240GH) | High pressure and temperature; steam, oil, gas | Unprotected against corrosion; needs coating in wet or corrosive service |
| Stainless steel | CF8 (304), CF8M (316), 1.4308 / 1.4408 | Corrosion resistance; food, chemicals, marine | Higher cost; 316 (molybdenum) outperforms 304 in chloride media |
| Brass | CW617N | Small-bore water, air and plumbing; easy to machine | Limited at high temperature and in aggressive water; lower pressure ratings |
| Bronze | — | Seawater and marine installations | Cost |
Seal and seat materials
Sealing depends on the seat and gasket material. The temperatures below are approximate; the exact limit is in the manufacturer’s data sheet.
| Material | Suitable media | Approx. temperature |
|---|---|---|
| EPDM | Water, hot water, air, mild chemicals (not for mineral oil or fuel) | approx. −40 … +120 °C |
| NBR (nitrile) | Mineral oil, fuel, air | approx. −30 … +100 °C |
| PTFE (Teflon) | Most chemicals; general-purpose ball valve seats | approx. −50 … +200 °C |
| FKM (Viton) | Oil, fuel, chemicals, high temperature | approx. −20 … +200 °C |
| Graphite | Steam and high temperature, fire resistance | 400 °C and above (depending on type) |
Practical selection tips
- Water and general lines: a ductile iron body with EPDM seats is often enough.
- Steam and high temperature: carbon steel body, with graphite or metal seats rather than PTFE.
- Corrosive fluid or food: stainless steel (304/316).
- Oil and fuel: NBR or FKM; do not use EPDM.
- If unsure, send us the fluid name, concentration and temperature and we will confirm the material together.
